How to Install an Outdoor Watering System With DIY Home Lawn Sprinkler Systems
Sprinkler systems, or otherwise known as “spoon” systems, are an essential component for any well-performing irrigation system. These systems are designed to prevent water from running slowly, causing it to run in a circular pattern, and also help control erosion in both hard and soft soil. When installing a sprinkler, you must follow certain rules to ensure that the entire system is installed properly. With that in mind, here are some tips to keep in mind when installing a sprinkler system.
The majority of lawn sprinkler systems today are hooked up either through a cable or by a water hook-up from the home. For this reason, it is important that each of these be installed properly. The average price of a professional lawn sprinkler installation might range anywhere from two thousand dollars to four thousand dollars, depending largely on the area being treated and the type of turf used at the home. Regardless of the price, however, the ease of installation makes installing a home lawn sprinkler system a very worthwhile investment.
When installing a lawn sprinkler system, the primary item to install first are the irrigation heads or tee-pots. These are typically made of PVC pipe, and they are located at the lowest part of the irrigation system, usually near the front of the home. The PVC pipe is secured to a steel ring, which is then attached to the sprinkler heads. To prevent leaks, make sure that the ring is screwed on tightly, especially if water is not supplied directly from the home. Leaks can be repaired with a simple repair, which will also prevent the water from leaking out of the tee-pot.
Next, the sprinkler heads themselves will need to be installed. These can either be left in place after the PVC pipe has been secured, or they can be replaced. In order to replace the heads, the old ones will need to be removed, while the new ones will need to be threaded on both ends and secured by caulking, as they do in the irrigation system. The heads can then be securely inserted into the pipe, and a new cap placed on top to keep everything tightly in place.
The final step of installing your home sprinkler system is to attach the hose and timer to the pvc pipe. This is usually done with stainless steel fittings, which are then screwed into the pipe. Once this is done, the hose can then be connected to the sprinkler heads, making sure that each section of lawn is getting adequate water. All hardware needs to be run through the hose to ensure that it remains waterproof, so it is important to run all of these piping through the basement.
With that completed, it is time to get to the really fun stuff. One of the most important parts of any sprinkler system is the control box. It will have either a metal handle or a switch located on the top. When this is turned on, the pressure from the water will begin to go through the pipes, controlling the spray. You will want to make sure that you have the correct control box for your system, which means contacting your Nancy foreman notes on the different types of systems she could recommend.
Once this step is complete, it is time to move on to the fun part: fixing the sprinkler heads. If you have an overhead system, like a water jet system, this should be relatively easy to do. If your irrigation DIY home lawn sprinkler system is a solenoid based, then you are going to have to use some sort of hole punching mechanism to get the heads into the hole. These can be purchased at any home improvement store or hardware store.
Once the holes are punched, you will need to clean up the debris and replace whatever was removed by the hole punching method. Make sure that you install the new sprinkler head in the same place as the old one, and make sure that it is securely holding the main water line. If you are not an experienced handyman, call in a professional to complete this step. Doing this work yourself is only going to lead to damage to your irrigation system, and can cause further problems down the road.
Check more information here https://www.bark.com/en/us/company/sprinkler-systems-san-antonio/JlQGm